Expedition truck camper: Steyr 12M18, MAN TGM 4x4, Iveco Daily 70C — box size, payload and what fits
· 8 min read
A typical expedition box is 2.24–2.31 m wide and 2.04–2.09 m tall inside, and 3.7–5.4 m long depending on the chassis — 4.63 m on a Steyr 12M18, 4.88 or 5.38 m on a MAN TGM 4x4, 3.70–5.24 m on an Iveco Daily 70C — with roughly 3.8–5.9 t of payload left for the interior, water and people. The width is the big change from a panel van: a 2 m mattress fits across the box with room to spare. The limits that bite are elsewhere: the licence class, the height of the truck, and how much garage you can have under a bed you can still sit up in.
I added these three chassis to VanPlot in October 2026 because an expedition builder on a Steyr 12M18 found no truck in the vehicle list. They are now real vehicles with real pages: Steyr 12M18, MAN TGM 4x4 and Iveco Daily 70C. This post is the numbers behind them, and what layouts they leave room for.
Where these numbers come from
A truck camper is two things: a chassis the maker builds, and a box a coachbuilder builds. The chassis figures — wheelbase, gross weight, cab width — come from the maker or an operator sheet: the Austrian Bundesheer data sheet for the 12M18, MAN's TGM chassis programme, and Iveco Australia's Daily cab-chassis spec sheet. The box is different on every truck, so each box below is a typical body actually sold on that chassis: Orangework and Excap builds on the Steyr, Woelcke and Orangework on the MAN, a Lamboo box on the longest Daily, scaled to the shorter frames. Every box figure is an estimate, and every van page says so.
The table: box, outside size and payload
Payload here is gross weight minus the chassis with its empty box shell — what is left for the interior, tanks, fuel, gear and people.
| Chassis | Wheelbase | Box inside (L × W × H) | Truck outside (L × W × H) | Kerb with shell | Gross | Payload left |
|---|---|---|---|---|---|---|
| Steyr 12M18 4x4 | 3,500 mm | 4.63 × 2.31 × 2.04 m | 6.80 × 2.43 × 3.65 m | ≈6,500 kg | 11,500 kg | ≈5,000 kg |
| MAN TGM 13.290 4x4 | 3,950 mm | 4.88 × 2.31 × 2.06 m | 7.70 × 2.43 × 3.72 m | ≈7,100 kg | 13,000 kg | ≈5,900 kg |
| MAN TGM 13.290 4x4 | 4,250 mm | 5.38 × 2.31 × 2.06 m | 8.40 × 2.43 × 3.72 m | ≈7,200 kg | 13,000 kg | ≈5,800 kg |
| Iveco Daily 70C | 3,750 mm | 3.70 × 2.24 × 2.09 m | 6.59 × 2.35 × 3.30 m | ≈3,150 kg | 7,000 kg | ≈3,850 kg |
| Iveco Daily 70C | 4,100 mm | 4.10 × 2.24 × 2.09 m | 6.99 × 2.35 × 3.30 m | ≈3,170 kg | 7,000 kg | ≈3,830 kg |
| Iveco Daily 70C | 4,350 mm | 4.50 × 2.24 × 2.09 m | 7.41 × 2.35 × 3.30 m | ≈3,200 kg | 7,000 kg | ≈3,800 kg |
| Iveco Daily 70C | 4,750 mm | 5.24 × 2.24 × 2.09 m | 8.28 × 2.35 × 3.30 m | ≈3,220 kg | 7,000 kg | ≈3,780 kg |
The Daily 70C rows are the rear-drive cab chassis with twin rear wheels — the common base for a 7-tonne box camper. Iveco's factory Daily 4x4 is a different chassis with its own frame height and weights; it is not in the database yet, so I have left its figures out rather than guess.
Payload: the problem changes, it does not go away
A 3.5 t van builder fights for every 10 kg. On these trucks the total is rarely the first limit. What binds first:
- The licence. The weight that decides your licence is the gross weight on the papers, not what the truck weighs today. See the next section.
- The finished weight is far above the shell. The 6,500 kg Steyr row is the bare chassis with an empty box. Typical finished 12M18 campers weigh about 8.1 t — so about 3.4 t is left of the 11.5 t, not 5 t. Plan from the empty shell, then add what a conversion actually weighs.
- Axle loads. Water tanks, batteries and a garage full of bikes all sit behind the rear axle on a long box. The weight distribution guide is written for vans, but the arithmetic is the same on a truck.
Licence classes: country-dependent, check yours
In the EU, the driving licence directive (2006/126/EC) sets the categories by the vehicle's maximum authorised mass: B up to 3,500 kg, C1 from 3,500 to 7,500 kg, C above 7,500 kg. On those lines, the Iveco Daily 70C (7,000 kg) is a C1 truck, and the Steyr 12M18 (11,500 kg) and MAN TGM (13,000 kg) need a full C licence.
What varies by country: whether an older licence already includes C1 (several countries kept old entitlements when the categories were harmonised), age and medical rules, speed limits and tolls above 3.5 or 7.5 t, and whether a motorhome is treated differently from a goods truck. Outside the EU — the UK, Switzerland, Serbia, North America — the lines are set by national, state or provincial law. I am not going to summarise those rules here; check with the authority that issued your licence before you buy.
One common plan does not survive the arithmetic: plating a Steyr 12M18 down to 7.49 t to drive it on C1. The empty shell leaves about 1,000 kg for everything, and a typical finished 12M18 is already over 7.5 t before water and people. A MAN TGM at about 7.1 t with its shell leaves less than 400 kg. If C1 is the limit, the Daily 70C is the chassis in this list built for it.
Height: 3.3–3.7 m outside
The Steyr and MAN builds stand 3.65–3.72 m tall, the Daily 70C about 3.30 m. Every 2 m barrier and most underground car parks are out, and low branches on forest tracks become a design input. Inside, a coachbuilt box has its insulation in the wall panels, so the 2.04–2.09 m is close to the finished height — there are no 7 cm of floor and ceiling build-up to subtract, as there are in a panel van.
What layouts fit
Fixed transverse bed. With 2.24–2.31 m between the walls, a 2.00 m mattress goes across the box with 24–31 cm to spare. A 1.40 m double then costs 1.40 m of box length. This is the default in nearly every truck box, and the reason the fixed vs. convertible bed question is easier here than in a van.
Wet room. A 0.8 × 0.9 m shower cubicle — the size the toilet and shower post works with — takes 0.9 m more. Bed plus wet room is 2.30 m, which leaves this much box length for kitchen and seating:
| Box | Length | After bed + wet room |
|---|---|---|
| Daily 70C, 3,750 wheelbase | 3.70 m | 1.40 m |
| Daily 70C, 4,750 wheelbase | 5.24 m | 2.94 m |
| Steyr 12M18 | 4.63 m | 2.33 m |
| MAN TGM, 3,950 wheelbase | 4.88 m | 2.58 m |
| MAN TGM, 4,250 wheelbase | 5.38 m | 3.08 m |
Dinette. The width is what makes a dinette work: a 60 cm kitchen counter on one wall and a 60 cm bench seat on the other still leave 1.04–1.11 m of aisle. So kitchen and dinette can face each other in the same stretch of box instead of queueing along one wall. On the shortest Daily the 1.40 m left over is one or the other; from about 2.3 m up, both fit side by side.
Garage under the bed. This is where the inside height bites. Using the numbers from the bed height vs. garage guide — 875 mm above the mattress to sit up, about 70 mm for the bed frame — and a 15 cm mattress:
| Box | Inside height | Highest sit-up platform | Clear garage | Fits |
|---|---|---|---|---|
| Steyr 12M18 | 2.04 m | 1,015 mm | ≈945 mm | road bike, wheel off |
| MAN TGM | 2.06 m | 1,035 mm | ≈965 mm | mountain bike, wheel off |
| Iveco Daily 70C | 2.09 m | 1,065 mm | ≈995 mm | mountain bike, wheel off |
None of the three gives the 1,100 mm an upright bike or a motorbike needs under a bed you can sit up in. A motorbike garage means a bed you only lie in, a taller box, or a rear rack outside. The garage dimensions guide has the clear heights for other loads.
Plan it on the real chassis
All three trucks are in the VanPlot planner with the box above, the weights and the payload bar ready to correct to your builder's numbers. Pick the chassis from the vehicle list, place the bed, wet room and dinette, and the payload and axle loads update as you go. If your box is not the typical one, type your own inside dimensions — the custom-vehicle step takes up to 18 t gross.
FAQ
How big is the box on a MAN TGM expedition truck?
A typical expedition box on a MAN TGM 13.290 4x4 is about 4.88 × 2.31 × 2.06 m inside on the 3,950 mm wheelbase and 5.38 × 2.31 × 2.06 m on the 4,250 mm wheelbase, with the finished truck 7.70 or 8.40 m long and about 3.72 m tall. The box is coachbuilt, so these follow real builds (Woelcke, Orangework) and are estimates — your builder's drawing wins.
What driving licence do I need for an expedition truck?
It depends on the country. In the EU, the licence directive 2006/126/EC sets category B up to 3,500 kg, C1 from 3,500 to 7,500 kg and C above 7,500 kg, by the vehicle's maximum authorised mass. An Iveco Daily 70C at 7,000 kg is a C1 vehicle there; a Steyr 12M18 (11,500 kg) or MAN TGM (13,000 kg) needs C. Older licences sometimes carry C1, and outside the EU the lines differ — check with your own licensing authority.
Can I plate a Steyr 12M18 down to 7.5 t?
On paper the chassis with a bare box shell is about 6,500 kg, which would leave about 1,000 kg under 7,490 kg. Typical finished 12M18 campers weigh about 8.1 t, which is over 7.5 t before any water or people. A down-plated 12M18 only works with a very light build; check the weight on a weighbridge before you count on it.
Does a transverse bed fit in a truck box?
Yes, with room left over. These boxes are 2.24–2.31 m wide inside, so a 2.00 m mattress goes across the box with 24–31 cm to spare — no flares, no cut-outs, unlike in a panel van.
How much payload is left in an expedition truck?
Gross weight minus the chassis with the box shell: about 5,000 kg on a Steyr 12M18, 5,800–5,900 kg on a MAN TGM 13.290 4x4 and 3,780–3,850 kg on an Iveco Daily 70C, before the interior, water, fuel and people. Those kerb weights are planning estimates; weigh the real truck.
Related: payload calculator