Skip to content
← All guides

Campervan dinette dimensions: bench depth, seat height, table size and the bed it turns into

· 8 min read

A campervan dinette that sits four and sleeps two needs about 1.95 m of van length from backrest to backrest, seats about 45 cm high and 50 cm deep, a 70 cm gap between the seat fronts, a table 72 cm high, and a bench 1.20–1.30 m wide — which, with a 50 cm aisle beside it, only a Ducato, Crafter, Sprinter, Transit or Daily has room for. Everything else in this post is how those numbers depend on each other, because in a dinette they do: the gap between the seats is also the bed's middle panel, and the table is that panel.

This is the dimensions post. Whether you want a dinette at all, or a fixed bed, is a separate trade — fixed bed vs convertible covers it. How many of those seats can carry passengers while driving is a legal question, answered in how many seats a camper van can have.

The seat: height, depth, backrest

A dinette seat is a dining chair, not a sofa. The working figures I plan with:

DimensionFigureWhy
Seat height (compressed cushion)43–46 cmFeet flat on the floor, thighs level; dining-chair height
Bench box under the cushion36–40 cmLeaves 8–10 cm for foam and is the bed's base height
Seat depth (front edge to backrest)45–50 cmDeeper and shorter people sit with their legs hanging
Backrest40–45 cm tall, leaning back 10–15 cmUpright enough to eat, reclined enough to sit for an evening
Head clearance above the cushion~90–95 cmRoughly the sitting height of a 1.75–1.80 m adult plus a little air

Measure the height from the finished floor. A typical floor build-up is 4 cm, which the bench box should not ignore.

The head-clearance line is the one that bites. Every large van with a standard roof has room: even a Ducato H1 is 1.66 m raw. The four common low-roof mid-size vans — Trafic, Vito, Transit Custom and Transporter H1 — are 1.38–1.42 m raw, about 1.31–1.35 m once the floor and ceiling are in. A 45 cm seat leaves 86–90 cm above it, which is short for a 1.80 m adult. Drop the seat to about 40 cm in those vans and accept slightly raised knees. The full headroom table is in which vans you can stand up in.

The wheel arches do not get in the way of seat height: in the planner's van data the arch tops sit 22–32 cm above the floor, below any bench box. A bench over an arch loses storage, not height.

The table: height, knee clearance, size

  • Top at about 72 cm from the finished floor — the planner's default table — which puts it 27–30 cm above a 43–46 cm seat. That difference matters more than either number on its own: under 25 cm and your thighs touch the underside; over 32 cm and you eat with your elbows raised.
  • No apron under the top. A 2–3 cm top on a single leg or a wall rail leaves about 20 cm of thigh clearance. A frame rail under the edge takes that away.
  • 60 cm of edge per person. Narrower is fine for a coffee, not for a plate and a laptop.
  • Depth = the gap between the benches. In a facing dinette the table spans from seat front to seat front, so its edges sit roughly over the front of each cushion.
Who sitsTable (width × depth)Bench width
Two, facing60 × 70 cm60–70 cm
Two each side (four)120 × 70 cm1.20 m
Bed-making dinette, doublebench width × gap, e.g. 125 × 70 cm1.20–1.35 m

The planner's default table is 80 × 60 cm on a 68 cm leg; resize it to your gap rather than the other way round. For working at the same table, the van desk post has the screen and keyboard heights.

Legroom between facing benches

Two people facing each other need their knees to pass. With 45–50 cm seats each knee sticks out 10–15 cm past the seat front, so:

  • 55 cm between the seat fronts is the minimum — knees interlock, you negotiate who stretches out.
  • 65–75 cm is comfortable for adults and is where most motorhome dinettes sit.
  • Over 80 cm and the table no longer reaches both seats unless it overhangs.

Add it up: two 50 cm seats, two backrests of 10–12 cm and a 70 cm gap is 1.90–1.95 m from backrest frame to backrest frame. That is not a coincidence. It is the length that turns into a 1.90 m bed.

How the dinette becomes a bed

The usual mechanism, and the dimensions it depends on:

  1. The table drops to bench-box height — 36–40 cm — onto ledges screwed to the inside of each bench front, or on a shorter or telescopic leg. The table top becomes the middle panel of the bed base.
  2. The backrest cushions lie flat on the table. Two backrests of 35–40 cm cover a 70 cm gap exactly; that is why the backrest cushion height should be half the gap.
  3. The seat cushions stay where they are, and the mattress surface ends up 45–50 cm off the floor — low, with the bench boxes as storage underneath.

The bed is then as long as the dinette (1.90 m from a 1.95 m dinette with thin backrest frames) and as wide as the bench. Sleeping on 8–10 cm of seat foam with two joints across it is the honest cost: the planner's double mattress is 18 cm thick for a reason. Some builders keep a 5 cm topper rolled up in a bench box.

A dinette with a 1.70 m backrest-to-backrest length still seats four. As a bed it sleeps someone up to about 1.65 m, or children — the family-of-four layouts post uses exactly that.

Three dinette layouts and the van width each one needs

1. Facing benches across the van, aisle beside. Benches face forward and backward, the bed runs lengthwise. The bench width is set by the aisle: the planner warns about any aisle under 50 cm. 2. Rear lounge. Two benches along the side walls at the back, facing each other across the van; filled in, it becomes a bed as long as the benches (1.90 m) and as wide as the van. 3. Cab seats plus bench. Swivel the cab seats to face a bench or a rock-and-roll bed behind them — the usual answer in a mid-size van, covered in the seats post.

Widths are bare wall to wall from the van database, minus 6 cm for insulated, panelled walls:

VanLoad floor (shortest–longest)Finished widthWidest bench with a 50 cm aisleRear-lounge gap (two 60 cm benches)
Fiat Ducato, Boxer, Relay, ProMaster2.67–4.07 m1.81 m1.31 m61 cm
VW Crafter, MAN TGE3.45–4.86 m1.77 m1.27 m57 cm
Iveco Daily2.61–5.13 m1.74 m1.24 m54 cm
Mercedes Sprinter2.61–4.71 m1.73 m1.23 m53 cm
Ford Transit3.04–4.22 m1.72 m1.22 m52 cm
Ford Transit Custom2.56–2.92 m1.72 m1.21 m51 cm
Renault Master, Movano, NV4002.58–4.38 m1.70 m1.20 m50 cm
VW Transporter T6.12.45–2.85 m1.64 m1.14 m44 cm
Mercedes Vito2.59–3.06 m1.61 m1.11 m41 cm
Renault Trafic, Vivaro, NV300, Talento2.54–2.94 m1.60 m1.10 m40 cm

What the table says:

  • A full double-width dinette bed (1.30 m or more) with a 50 cm aisle fits only the Ducato family. The Crafter gets close at 1.27 m. Everything else from the Daily down tops out at 1.20–1.24 m — a small double — unless you accept a narrower aisle.
  • The rear lounge is a large-van layout. Only the Ducato (61 cm) and Crafter (57 cm) leave comfortable legroom between side benches; the other large vans sit knee to knee at 50–54 cm, and the mid-size vans at 40–44 cm cannot take a table between them. In exchange, the rear lounge sleeps on the full width: 1.90 × 1.70–1.81 m.
  • Mid-size vans fit one layout well: the cab-seat dinette. A 1.10–1.14 m bench behind swivelled cab seats is the standard Transporter and Trafic answer.

How much van length a dinette leaves

The dinette is 1.95 m of floor. Add a lengthwise fixed bed of 1.90 m and you need about 3.85 m of load floor before the kitchen. That leaves the Ducato L4 (4.07 m), Sprinter L3 and L4 (4.31 and 4.71 m), Transit L4 (4.22 m), Crafter L4 and L5 (4.30 and 4.86 m), Master L4 (4.38 m) and Daily L4 and L5 (4.68 and 5.13 m). A transverse bed instead saves about half a metre, but only the Ducato is wide enough for most adults to sleep across.

In every shorter van — every L2, every mid-size van — the dinette is the bed, and the remaining 0.5–1.8 m of floor holds the kitchen, a washroom or a garage. That is the real argument for a dinette: in a Ducato L2 (3.12 m) it gives you a table for four and a bed in 1.95 m, where a fixed bed plus a separate table would not fit at all. The kitchen dimensions post has the counter lengths for the floor that is left.

Weight

In the planner's catalog a bench is 25 kg, a table 12 kg and a leg 2 kg, so a two-bench dinette is about 64 kg before cushions — similar to a fixed bed frame and mattress. The weight sits low and usually near the middle of the van, which is good for the axles.

Check it in your van

Every number above is a starting point, and the tight ones — a 52 cm aisle, a 54 cm rear lounge — depend on your exact variant and wall build-up. In the planner, pick your van from the 53 bases and 277 variants, drop in two benches and a table, and the aisle check and measuring tool tell you what is left. For the bed itself, the bed height calculator shows what sitting up costs at each height.

FAQ

What seat height should a campervan dinette have?

About 45 cm from the finished floor to the top of the compressed cushion — a 36–40 cm bench box plus 8–10 cm of foam. That is ordinary dining-chair height and puts a 72 cm table 27 cm above the seat. In a low-roof mid-size van (1.38–1.42 m raw) drop the seat to about 40 cm so a seated adult's head clears the roof.

How long does a dinette need to be to turn into a bed?

About 1.95 m from backrest to backrest for a 1.90 m bed. With two 50 cm seats that leaves a 70 cm gap between the seat fronts, which is comfortable legroom by day and is filled by the lowered table plus the backrest cushions at night. A 1.70 m dinette seats four fine but only sleeps someone up to about 1.65 m.

How big should a campervan dinette table be?

60 cm of table edge per person and a depth equal to the gap between the benches. For two people facing each other that is about 60 × 70 cm; for four, two per side, about 120 × 70 cm. If the dinette becomes a bed, the table is also the bed's middle panel, so make it exactly the gap by the bench width.

Which vans fit a dinette and a fixed bed?

A lengthwise 1.90 m bed plus a 1.95 m dinette needs about 3.85 m of load floor: the Ducato L4 (4.07 m), Sprinter L3 and L4 (4.31 and 4.71 m), Transit L4 (4.22 m), Crafter L4 and L5, Master L4 (4.38 m) and Daily L4 and L5. In anything shorter, the dinette is the bed.

How wide can a dinette bed be?

As wide as the bench, and the bench is limited by the aisle beside it. Keeping a 50 cm aisle, the widest bench is about 1.31 m in a Ducato, 1.22–1.27 m in a Sprinter, Transit, Crafter or Daily, 1.20 m in a Master and 1.10–1.14 m in a Trafic or Transporter. A rear lounge across the van uses the full finished width instead: 1.60–1.81 m.

Your van is waiting. Measure it, then plan it.

In sixty seconds you'll be dragging a bed into a Ducato. Free, in your browser.

Vladimir Šterjoski

Who makes this

I'm Vladimir. I'm planning my own conversion, and none of the tools I tried could tell me whether a layout would fit or what it would do to the rear axle, so I made this one. I work on it alone. If something's wrong or missing, write to me — the address goes to my inbox.

Vladimir Šterjoski

vladimir@vanplot.comWhy I made it